Tag: Springs

A Few Things…

Additional work has been completed since the suspension rebuild, none worthy of a single blog post, but here goes;

Front Springs

After I had replaced the rear springs as (see the previous post), It can only help to replace the front rusty, flaky ones too. I picked some 250lb  springs up from Protech then, it was a simple job; remove the retaining bolts – viciously cut off the old springs with an angle grinder, then slip on the new (shorter) springs and re-installing. The ride height was matched side to side but needs another look as the whole car seems a bit low.

After a couple of drives with the new springs – the car bucked around a little when on bumpy surfaces – so I clicked the dampers down one level all-around. 
MAP Sensor Damper
When completing the Ignition system a couple of years back, a Danst Engineering damper was added to smooth out the pulses created by the intake system and provide a good reading to the MAP sensor. I fitted it below the inlet manifold sort of hanging on the vacuum lines. Then after watching a youtube video from Japan about a Toyota AE86, and seeing a nice setup, I decided to copy it. Basically, the damper was moved to the edge of the cam cover fastened by p-clips and plumbed in with fresh silicone hoses.
Look, I’ve added an arrow to help you spot it!

More Wheels
When I got my current tyres fitted (Nankang NS2R), the man in the workshop noted that one rear wheel had hit something pretty hard and dented the OSR wheel rim (inside and out) – this presents itself as a rumble at higher speeds. 
This gave me an excuse to find more wheels (again) after waiting and watching I found some 13inch Minilite replicas (these cars are supposed to handle better on 13’s) I collected them and got them on – the car feels lighter on its toes and I think they look great!
I’ll probably go back to the 15inch wheels for another year or so to wear the tyres out, then get some new 13inch tyres and switch to these full time.